HOOK KIT INSTRUCTIONS
Hook
Bracket
Hole
5) Drill and secure the bracket to the vehicle with self-
tapping screws using the two pilot holes on the bottom of
the hook bracket as a guide.
6) Once the bar is secure, drill a one-inch hole to route the
wire harness through the vehicle and then seal the hole
with silicone. Ensure that wires are protected from rough
edges using a rubber wire grommet.
Pilot
Holes
INSTALLING A HOOK BRACKET
1) Remove the hex bolt from its packaging and slide the
bolt through the hook bracket hole. See figure A.
2) Using a socket wrench and the hex bolt, loosely secure
the hook bracket to the threaded hole in foot bracket.
Repeat on the other side of the lightbar so both sides have
the hook bracket secured. See figure B.
3) Place the lightbar with the attached hook brackets on
the vehicle. Ensure the hook bracket is up right and seated
correctly. See figure C.
4) Secure and tighten the bracket using a socket
wrench on each side of the vehicle until the bar is snugly
mounted. Use the included lock nut as a jam nut for extra
security. Ensure the vehicle’s door will close without any
interference.
Threaded
Hole in
Foot Bracket
Hook
Bracket
Figure A.
Figure B.
Figure C.1
- Top View
Figure C.2
- Bottom View
Figure C.3
- Side View
Lock Nut
Bolt
Utilizing non-factory hardware and mounting brackets may
result in loss of warranty coverage.
Use the “Hook Kit Compatibility Chart” for more information on
page 8 of this manual.
Do not overtighten the hex bolts. Do not exceed 165 in. lb.
The use of blue thread locker is suggested.
V
3.1
TM
FENIEX.
2019
INSTRUCTION MANUAL
WEB.
www.feniex.com
7