WIRING & FUNCTIONS
WIRING DIAGRAM: STANDARD CONFIGURATION
Wire Color
Function
Polarity
Description
Black
Ground
12v (-)
Connect to vehicle's negative battery post
Red
Positive
12v (+)
Connect to vehicle's positive battery post
Brown
Mode 1
12v (+)
Mode 1 Activation (All Positions)
Green
Mode 2
12v (+)
Mode 2 Activation (All Positions, Overrides Mode 1)
Yellow
Work Light/Pattern
12v (+)
Programmable, Work Light Activation or Pattern Changer
White
Tail Lights
12v (+)
Activates Tail Light function (if equipped)
Blue
Left Brake Light
12v (+)
Activates Left Brake/Turn function (if equipped)
Gray
Right Brake Light
12v (+)
Activates Right Brake/Turn function (if equipped)
All user-supplied wires connecting to 12v (+) or 12v (-) must be sized to supply 100% of the maximum current and properly fused at the
power source with a fuse rated at 125% of the total circuit load. Avoid routing wires in the deployment area of the vehicle air bag or any
other potentially hazardous locations.
The yellow wire is user-programmable between work light activation and pattern changer. See below for programming instructions.
POWER CABLE WIRING
1) Install a customer-supplied fuse rated for 125% of the
circuit load to the end of the red wire. Do not use a circuit
breaker or fusible link.
2) Connect the opposite end of the fuse to the 12v+
terminal of the battery. Do not use more than 1 foot of
wire between the fuse and the battery terminal to ensure
appropriate protection.
3) Connect the black wire to the vehicle chassis ground.
4) Connect the function wires to switches, depending on
the functions needed for applications (See chart above).
WARNING MODES
Activate the warning modes by extending the blue/white
(front) and green/white (rear) wires to 12v (+) latching
switches to activate mode 1 (front and/or rear as desired).
When power is supplied to mode 2 (black), the pattern will
be changed for the active display. When power is supplied
to Mode 3 (red) or mode 4 (orange) wires, the selected
pattern for each mode will display on the whole bar (front
and rear).
FLASH PATTERNS
While the yellow wire is programmed for pattern selection
mode, advance the pattern applying 12v (+) for 1 second.
Continue to do this until the desired pattern is displayed.
CRUISE MODE
Cruise mode is available as a pattern. While either Mode
1 or Mode 2 is active, select pattern #14. This will set the
active mode's pattern to "Cruise", which will display the
corner and side modules @ 10% intensity.
WORK LIGHT OR PATTERN SELECTION MODE
To toggle between the yellow wire activating either work
light mode or pattern selection mode, do the following:
1. Apply 12v (+) to the red wire.
2. Within 5 seconds after connecting the red wire, tap the
yellow wire 5 times to the 12v (+).
With each tap, the work lights should activate and on the
5th tap the work lights will turn off by themselves.
3. The yellow wire is now the pattern changer wire.
This will only work if the red wire is activated to a 12v (+)
WORK LIGHTS
While the yellow wire is programmed for work light
activation mode, apply 12v (+) to activate the work lights.
The Fusion TOW Series 49" Lightbar does not come standard
with Stop/Tail/Turn functionality, this feature must be specified
at the time the product is ordered from the factory.
FENIEX.
2019
INSTRUCTION MANUAL
WEB.
www.feniex.com
5
V
3.1
TM
