WIRING, CONFIGURATION, & MOUNTING INSTRUCTIONS
COLOR
FUNCTION POLARITY
CONNECTION
Red
Mode 1
12v (+)
Latching Switch
Black
Gound
12v (-)
Chasis Ground
Green
Pattern
Changer/
Sync
12v (-)
Momentary Switch
White
Mode 2
12v (+)
Latching Switch
WIRING DIAGRAM
SETTING MASTER/SLAVE
For the light heads to alternate, one light head must be
set as master and the other as slave on the mode wire
intended for use. To do so, hold the green (flash pattern
changer) wire to ground for 3 seconds.
For Single color: if all LEDs turn on, this indicates master
mode. If no LEDs turn on, this indicates slave mode.
For Dual color: if all LEDs turn on, this indicates master
mode. If half of the LEDs turn on, this indicates slave
mode.
POWER
To operate the cigarette plug option, plug in the provided
lighter plug into the vehicle's cigarette lighter plug outlet.
Turn the unit on with the On/Off switch and change
patterns with the momentary flash pattern changer.
PATTERNS & SYNCHRONIZATION
1)
Momentarily tap the green wire to a ground 12v (-)
source to cycle through the flash patterns.
2)
Synchronization: To synchronize two or more Fusions
(or compatible products) together:
A)
Choose the desired flash pattern for each unit.
B)
Connect the green wires of the light heads
together.
To achieve syncronization, the patterns must match on all
products connected to the synchornization circuit.
Each time the master/slave mode is set, the pattern will reset
to the default setting (Single Flash [Slow]). This simplifies the
process of synchronizing two or more compatible products.
The Fusion 1X & 2X can be synchronized with other compatible
products with matching patterns (single color). Consult the
instruction manual of each product as the process may differ
by model.
MOUNTING INSTRUCTIONS:
SUCTION CUP:
Make sure the suction cups have been cleaned with
alcohol to remove all residue.
Stick lights onto the interior of the vehicle dash window.
PERMANENT MOUNT:
Cleaning Instructions:
1.
To obtain optimum adhesion, use a non-amonia based
de-greaser to clean the surface you will adhere the mount
to.
2.
Place tape inside the surface mount and press onto
back of Fusion 1X or 2X with 15 psi's of pressure. Full
adhesion is reached after 72 hours.
Refer to 3M Surface preparation document for detailed
instructions.
Surface Prep:
http://multimedia.3m.com/mws/media/66019O/
vhbtm-tape-surface-preparation-technical-bulletin.
pdf?&fn=87015.pdf
Tape Product Description:
https://multimedia.3m.com/mws/media/67100O/3mtm-
vhb-tapes.pdf
Mode 2
Mode 2
Flash Pattern
Flash Pattern
Mode 1
Mode 1
Single Color
Dual Color
FENIEX
//
2019
// INSTRUCTION MANUAL // v3.0
WEB
//
www.feniexindustries.com
5
TM
