1.1 Safety instructions
1.1.1 Safety briefing and measures
Important notes on work safety
The statutory accident prevention regulations (available from professional associations or specialist shops)
must be observed. These depend on the operating site, operating mode and fuels and lubricants used.
Additional protective measures dependent on the respective procedures are specified in the corresponding
repair guidelines and highlighted.
Safety instructions
This handbook uses the following safety tips:
DANGER:
This symbol, together with the word DANGER, means there is an immediate risk of danger
that must be avoided. Otherwise there is a risk of death or very serious injuries.
WARNING:
This symbol, together with the word WARNING, means there is a potential danger that
must be avoided. Otherwise there is a risk of death or serious injuries.
CAUTION:
This symbol, together with the word CAUTION, means there is a potential danger that
must be avoided. Otherwise there is a risk of minor injuries.
Please observe the following when carrying out maintenance or service work to the tractor:
The specific documentation associated with the vehicle (Workshop Service Manual and Operator's Manual)
must be used to complete any pending work.
1. General
• Only briefed personnel may operate the tractor or carry out maintenance work.
• Only use qualified specialists to carry out repairs or service work.
• Nobody may be in the cab while work is being carried out under the jacked-up tractor.
• Pressure lies from implements must be discharged.
• Nobody is allowed to be in the area of a lifted, unsecured load (e.g. raised cab).
• Safety guards must not be opened or removed while the engine is running.
• Pressurized fluids (fuel or hydraulic oil) escaping under high pressure can penetrate the skin and cause
severe injuries. If injuries occur, seek medical advice immediately to avoid the risk of serious infection.
• A safe distance must always be kept from hot surfaces.
• Pressure accumulator and connected lines are under high pressure. Only carry out removal and repair
work in accordance with instructions in the Workshop Service Manual.
• To avoid eye injury, do not look directly at the surface of the activated radar sensor.
• Always dispose of oils, fuels and filters properly.
• Specialist knowledge and special fitting tools are required to fit tires.
• Run the tractor for a short time, then all wheel nuts and bolts must be retightened and checked
regularly. Torque values can be found in the technical data.
• Before working on the electrical system, the earth cable must always be removed from the battery.
Before carrying out electric welding work on the tractor or mounted implements, ensure that both
battery terminals are disconnected. Attach the welding appliance's earth terminal as close to the
welding spot as possible.
• Always exercise caution when working with brake fluid and battery acid. These substances are toxic and
corrosive.
• Only FENDT original spare parts must be used.
[V]
GUID-69CA5D37-9E43-4DCA-8196-B58F2F35056D [V3]
1. 00-000 Entire vehicle system
FENDT 900 Vario Gen6
1-5
X990005734011
Find manuals at https://best-manuals.com
