Fender MUSTANGMINI Advanced Owner'S Manual Download Page 3

MUSTANG

 MINI

  You  can  completely  change  the  list  of  effects  available  on 

your Mustang Mini amplifier as well as access bonus effect 

parameters using Fender FUSE software! 

The three LEDs next to the EXIT button are numbered to indicate 

which effect position (1, 2 or 3) is being selected within each of the 

four selection ranges (A, B, C and D).  For example, effect selection 

"A1" is shown below:

Effects Level

To adjust the level of effects for the current preset, press and hold 

the EXIT button while turning the EFFECTS knob:

1

2

3

Tap Button

The TAP button can be used to tap in delay time and modulation 

rate settings for the current effect:

•  Delay time — 

TAP button blinks 

green:

•  Modulation rate — 

TAP button blinks 

red:

When  you  select  a  delay  type  effect,  the  TAP  button  will  blink 

green 

in  sync  with  the  delay  time  setting.  When  you  select  a 

modulation type effect, the TAP button will blink 

red

 in sync with 

the modulation rate setting. 

To set the TAP interval of effects:

1.

  Select an effect that causes the TAP button to blink, using the 

EFFECTS knob.

2.

  Press  the  TAP  button  twice  rhythmically  in  time  with  the 

desired interval.

  Press  the  TAP  button  just  one  time  to  set  the  delay  or 

modulation interval to its maximum value. 

Guitar Tuner

Your Mustang™ Mini amplifier has a built-in Tuner mode that uses 

the control panel LEDs as a chromatic guitar tuner. 

To use the tuner:

1.

  Press and hold the TAP button for 2 seconds. The TAP and EXIT 

buttons will illuminate.

2.

  Strike  any  single  string  on  your  guitar  and  watch  the  panel 

LEDs.  The  Preset  LEDs  are  used  to  indicate  the  note  of  the 

string being tuned (the top LED "#" also lights up to indicate if 

the note is sharp).

1 2 3

3.

  Turn the tuning peg on your guitar until the fine tuning LEDs 

next  to  the  EXIT  button  indicate  that  the  string  is  in  tune,  as 

shown above.

4.

  Standard guitar tuning is as follows:

5.

  Press EXIT or TAP to exit from the Tuner.

Letters next to LEDs indicate the note being tuned

3 LEDs indicate fine tuning. 

GREEN

 means "in tune"

Adjusting the EFFECTS level

3

f e n d e r . c o m

Reviews: