NOTE: DO NOT BLOCK THE AIR FLOW TO THE REAR PANEL;
FOR EXAMPLE, BY BACKING THE AMPLIFIER UP AGAINST A
WALL.
The rear panel is used to keep the output devices from
getting too hot.
POWER CORD -
This amplifier is equipped with a grounding
type supply cord to reduce the possibility of shock hazard. Be
sure to connect it to a grounded AC receptacle. The line cord
should be connected to a suitable power source, in
accordance with the voltage and frequency as shown by the
power rating on the rear panel.
DO NOT ALTER THE AC
(MAINS) PLUG.
WARNING: THIS EQUIPMENT MUST BE GROUNDED.
COVERING CARE-
The exclusive vinyl covering on your
cabinet has been especially designed for years of lasting
beauty. A very light, soapy solution on a sponge may be used
to remove dirt and residue that may accumulate in the
texture. Be careful not to let any liquid come in contact with
the operating surfaces.
UNPLUG THE POWER CORD BEFORE
CLEANING.
If the amp is set up but does not function, check the following items:
- Is the amp power cord plugged into an electrical outlet?
- Is there power at the outlet?
- Are all the control knobs turned up?
- Is the volume control on the instrument turned up?
- Is the instrument properly plugged into the amplifier?
(Eliminate any effect pedals and try another guitar cord.)
If, after checking all of the above, the system is still not performing correctly,
consult your FENDER Service Dealer.
Troubleshooters Checklist
KXR 100 Rear Panel Functions
