NOTE: DO NOT BLOCK THE AIR FLOW TO THE REAR PANEL,
FOR EXAMPLE, BY BACKING THE AMPLIFIER UP AGAINST A
WALL.
The rear panel is used to keep the output devices from
getting too hot. Should the amplifier overheat, a thermal
switch will shut the amplifier off until the output devices cool.
POWER CORD -
This amplifier is equipped with a grounding
type supply cord to reduce the possibility of shock hazard. Be
sure to connect it to a grounded AC receptacle. The line cord
should be connected to a suitable power source, in
accordance with the voltage and frequency as shown by the
power rating on the rear panel. If you are not sure, check
some other piece of equipment in the area.
DO NOT ALTER
THE THREE PRONG PLUG.
If the amp is set up but does not function, check the following items:
- Is the amp power cord plugged into an electrical outlet?
- Is there power at the outlet?
- Are all the control knobs turned up?
- Is the volume control on the instrument turned up?
- Is the instrument properly plugged into the amplifier?
(Eliminate any effect pedals and try another guitar cord.)
If, after checking all of the above, the system is still not performing correctly,
consult your FENDER Service Dealer.
COVERING CARE
The exclusive vinyl covering your cabinet has been especially
designed for years of lasting beauty. A very light, soapy
solution on a sponge may be used to remove dirt and residue
that may accumulate in the texture. Be careful not to let any
liquid come in contact with the operating surfaces.
UNPLUG
THE POWER CORD BEFORE CLEANING.
Troubleshooters Checklist
BXR 100 Rear Panel
