12
Connecting connectors
Models fencee
energy Smart DUO EDW
have two waterproof input connectors; upper one
for adapter connection and lower one for battery connection. Connectors may be wrongly
connected thus always make sure that the correct connections taken place. This design has
preference for connecting to the mains voltage with the option of connecting to the battery,
as a backup power supply in the event of power failure. Running the energizer for a long time
just from the battery is not desirable due to the higher energy consumption and low capacity
of conventional batteries.
Upper connector
for
ADAPTER
Lower connector
for
BATTERY
Earthing
Correct earthing is very important because total function of the fence system is
dependent on it!
Beat earthing rod with corrosion protection into ground completely at place with maximum
and permanent humidity. On dry pieces of land or in case of soils with lower electric
conductivity, use one or several supplementary earthing rods (with length of minimum of
1 m) and place them at distance of approximately 3 metres from each other.
Exceptions are fence system powered by battery energizer or working with low output. Here
minimum length of earthing rod of 50 cm is recommended. Distance of at least 10 metres must
be between earthing rod of fence system and another earthing system, for example earthing
of a house, protective earthing of electric supply system or earthing of violation alarm.
Do not connect the energizer to already existing earthing.
Antenna installation
Screw the Wi-Fi antenna onto the SMA connector.
If one of the connectors is not used then the connector cover
must be screwed in to keep the connector watertight.
If the the adapter and battery are connected to wrong co-
nnectors, charging and the low battery indication will not work
and the battery will not be discharging.