*
Detailed Steps
Red light lamps
Infrared light lamps
Cleanse the face.
During treatment, start at the bottom of the face and move
upwards.
Note:
STEP1:
STEP2:
Tip：
①
②
①
②
The device only starts functioning when the built-in intelligent infrared sensor system senses the
skin
*
In order to avoid overuse, the default treatment time of the Nano Meso Mode is 10 minutes each
time, after which the device will continuously beep twice to remind you the treatment has finished.
*
In order to avoid overuse, the default treatment time of the Phototherapy Mode
is 20 minutes each time, after which the device will continuously beep twice to remind you the
treatment has finished.
Follow the "Installation of cartridge with serum” instructions to
install the cartridge with serum.Press the Nano Meso Mode
button to turn on the Nano Meso Mode ; If you need to adjust
the intensity, you can press the Nano Meso Mode button
again to select the desired intensity. For specific usage, please
refer to the instructions in the "Description of the modes".Posi-
tion the Nanocrystalline needle surface in horizontal contact
with the skin, you will observe a slight downward motion of the
needle surface. To start the treatment, gently but quickly move
the device up and down.The used force should be adjusted
according to the contact with the skin.
*
The infrared light wavelength is beyond the visible range of the naked eye, therefore this light is not
visible during the Phototherapy Mode
Nano Meso Mode
