Fema M Series, User Manual, Page: 20 / 36

FEMA ELECTRÓNICA . SERIES M . M60-LC
20
1.12.17 Tools
1.12.18 Access to options configurations menu
Tools Password
Version
Factory
configuration
Minimum
Brightness
Maximum
Standard
Reset
‘initial conf.’
Access to the optional module installed at slot 1
Access to the optional module installed at slot 2
Access to the optional module installed at slot 3
The ‘OPt.1’, ‘OPt.2’ and ‘OPt.3’ menu entries give access to
the configuration menus for the optional modules installed at
Opt.1, Opt.2 and Opt.3 slots.
See section
2
for a list of the different modules available that
can be installed on each slot. The configuration menu for each
module is described at the User’s Manual of each module.
The ‘ Tools ’ (‘ tooL ’) menu groups functions with a variety of
uses.
•
at the ‘ Password ’ (‘ PASS ’) function define a 6 digit code to
block access to the ‘configuration menu’. Activate the pass -
word to prevent access to the instrument configuration by
non authorized personnel. To activate the ‘ Password ’ func -
tion select ‘ on ’ and enter the code.
The numerical code is asked when accessing the ‘configu -
ration menu’ (key‘SQ’ (
<
)). Functions configured to be ac -
cessible through the ‘fast access’ menu are not ‘ Password ’
blocked.
•
at the ‘ Factory configuration ’ (‘ FAct ’) select ‘ yes ’ to acti -
vate the default factory configuration (see section
1.14
for a
list of default parameters). The cell configuration parameters
(‘ Initial conf. ’ (‘ Init ’) menu) are not affected by this reset if
the ‘ Reset ‘initial conf. ’’ (‘ F.InI ’) parameter is ‘ off ’.
•
at the ‘ Reset ‘initial conf ’’ (‘ F.InI ’) parameter select ‘ on ’ to
include the cell configuration parameters when activating
the default factory configuration.
The factory reset applied to the ‘initial configuration’
parameters affects the cell configuration parameters.
For a correct reading, a new cell configuration must
be applied, as indicated in section
1.12.2
.
!
•
the ‘ Version ’ (‘ VEr ’) parameter informs about the firmware
version loaded on the instrument.
•
At the ‘ Brightness ’ (‘ LIGh ’) parameter select the intensity
of the display brightness. Five levels available. With this
function the instrument brightness can be adapted to match
the brightness of nearby instruments.