Fema M Series, User Manual, Page: 25 / 36

FEMA ELECTRÓNICA . SERIES M . M60-LC
25
1.14 Factory configuration
Initial configuration (‘ InIt ’)
Load cell parameters (‘ cELL ’)
Decimal point (‘ dP ’) without (XXXXXX)
Sensitivity mV/C (‘ MV.V ’) 2.0000
Nominal weight(‘ LoAd ’) 200000
Excitation voltage (‘ V.Exc ’) 10 Vdc (‘ 10 ’)
Advanced configuration (‘ AdVc ’)
Auto-tare (‘ Aut.t ’)
Activation value(‘ SEt ’) 10
Stability band (‘ bAnd ’) 0 (disabled)
Stability time (‘ tIME ’) 0.0 (disabled)
Maximum tare (‘ MAX.t ’) 999999
Scale factor (‘ ScL.F ’)
Multiplier (‘ MuLt ’) 1
Divider(‘ dIV ’) 1
Stock units (‘ Stck ’) 0 (disabled)
Mode (‘ ModE ’) standard (‘ Std ’)
Alarms 1,2 and 3 (‘ ALr.1 ’, ‘ ALr.2’, ‘ALr.3’ )
Active (‘ Act ’) off (disabled)
Type (‘ tYPE ’) maximum (‘ MAX ’)
Setpoint (‘ SEt ’) 1000
Hysteresis (‘ hYSt ’) 0 counts
Activation delay (‘ dEL.0 ’) 0.0 seconds
Deactivation delay (‘ dEL.1 ’) 0.0 seconds
Stability (‘ StbL ’)
Stability band (‘ bAnd ’) 10 counts
Stability time (‘ tIME ’) 0.0 (disabled)
Setpoint 2 (‘ SEt.2 ’) off (disabled)
Inverted relay (‘ r.InV ’) off
Locked alarms (‘ A.LcK ’) off
Display (‘ dISP ’)
Fixed digits (‘ FIX.d ’) no fixed digits (‘ ------ ’)
Average filter(‘ AVr ’) 0 (disabled)
Steps (‘ StEP ’) 1
Left zeros (‘ LZEr ’) off
Memory of maximum (‘ MAX ’) -199999
Memory of minimum (‘ MIn ’) 999999
Rear controls (‘ r.ctr ’) all ‘off’
Key LE (‘ K.LE ’)
Tare on
Alarm unlock off
Stock units off
Key UP (‘ K.uP ’) all ‘off’
On power up
Delay 0
Tare off
Tools
Password (‘ PASS ’) off
Reset ‘initial conf.’(‘ F.Ini ’) off
Brightness (‘ LIGh ’) 3
Messages and errors
‘d.udr’
‘d.oVr’
display underrange (‘ d.udr ’) / overrange (‘ d.ovr ’). The
display is already reading the minimum / maximum
value possible (-199999 / 999999).
‘Err.0’
incorrect scaling (vertical slope)
‘Err.1’
incorrect password.
‘Err.2’
when accessing an ‘ oPt.X ’ menu entry, there is no rec -
ognize module installed.
‘Err.6’
in ‘stock units’ mode, weight value is 0 and can not be
assigned to a quantity of units.
‘Err.8’
over current at the excitation voltage.
‘----’ requested reading is not accessible (reading of units
with the ‘stock units’ mode disabled).
Table 6 - Messages and error codes
Error messages are informed flashing on display.
1.15 Messages and errors