Fema B Series, User Manual, Page: 23 / 36

FEMA ELECTRÓNICA . SERIES B . Models Bxx-RTU
23
1.21.16 ‘Fast access’ configuration menu
Key UP
(‘Fast access’)
At the ‘ Key UP (‘fast access’) ’ (‘ K.uP ’) menu configure which
functions and parameters will be accessible through the ‘fast
access’ menu. Select ‘ on ’ to activate each function. For more
information see section 1.21.11.
• the ‘ Bus activity ’ (‘ buS.A ’) function allows to visualize if
there is activity at the communications bus
(see 1.21.12)
.
• the ‘
Memory of maximum
’ (‘
MAX
’) or ‘
Memory of mini-
mum ’ (‘ MIn ’) functions allow to visualize the maximum or
minimum reading value stored in memory.
• the ‘
Setpoint 1 ’ (‘ ALr1 ’) function allows to visualize and
modify the alarm 1 setpoint through the ‘fast access’ menu.
Only in ‘Process slave’ mode.
• the ‘
Setpoint 2 ’ (‘ ALr2 ’) function allows to visualize and
modify the alarm 2 setpoint through the ‘fast access’ menu.
Only in ‘Process slave’ mode.
• the ‘
Setpoint 3 ’ (‘ ALr3 ’) function allows to visualize and
modify the alarm 3 setpoint through the ‘fast access’ menu.
Only in ‘Process slave’ mode.
• the ‘
Address ’ (‘ Addr ’) function allows to visualize the ad -
dress of the instrument.
On Power-Up Delay Seconds
The ‘ On Power Up ’ (‘ on.Pu ’) menu assigns functions to be applied
when the instrument starts after a power loss. For more informa-
tion see section 1.21.13.
• at the ‘
Delay
’ (‘
dLAy
’) parameter configure the time the in -
strument will wait before starting normal functionality. Time
between 0 and 200 seconds.
• at the ‘
Alarm 1 ’, ‘ Alarm 2 ’ and ‘ Alarm 3 ’ parameters config -
ure the state for the alarms at power up.
Memory of
maximum
Memory of
minimum
Setpoint 1
Setpoint 2
Setpoint 3
Bus activity
Address
Alarm 1
Alarm 2
Alarm 3
1.21.17 ‘On power up’ configuration menu
1.21.18 Setpoint on bus’ configuration menu
Setpoint on
bus
Available in ‘Process slave’ mode only. Enables access to the
alarm setpoint registers through the bus. For more informa -
tion see section
1.21.14.
1.21.19 ‘Decimal point’ configuration menu
Remote Decimal point
Place with LE Manual
Only available in ‘Process slave’ mode. Set to ‘
Manual
’ to
manually configure the position of the decimal point. For
more information see section
1.21.15.