2
Mounting instructions
for the retractable undercarriage
Firm attachment between two fuselage bulkheads
Attach the retractable undercarriage carefully to avoid problems in flight practice. Please regard
the following notes thoroughly.
Up to four servos can be attached to the undercarriages with the stock numbers 9800A, 9810A
and 9820A. To the undercarriage with the stock number 9830 up to two servos can be attached.
The supports have all necessary fastening bores. The wheel bow of stainless spring steel
makes the retraction easier and guarantees a safe functioning of the fuselage flaps.
Position of the retractable undercarriage in the fuselage
At most modern sail planes, the axle of the extended wheel is located just vertically below the
leading edge stringer strip. The aeromodelling practice, however, has shown that the model too
easily bends its nose down when starting a towed flight and landing. It is advisable to mount
the axle nearer to the front of the model. We recommend to shift it 5-15° to the front in relation
to the vertical below the stringer strip.
Fuselage opening and position of the fl aps
The width of the opening should be 2 mm smaller than the dimension “B” of the undercarriage.
The length of the opening depends on the wheel diameter. Determine the dimension of the front
edge of the oscillating cranks (extended) and measure the round shape of the flaps according
to the graphic. The preparation of a firm cardboard template is advisable for the superficial
fissure of the saw line. The stronger the superficial fissure, the easier to use the saw. A small
electronic compass saw is ideal, but if not available it is also possible to use the saw blade of a
small coping saw. Separate the cut out piece right in the middle. A piece of a racing cycle’s thin
tube is suitable as hinge for the flaps. Cut off strips that are 2 cm wide and of the appropriate
length. Punch holes into the middle of the rubber strip with the help of a splayed brass pipe
(see graphic). These hinges are really robust and adapt to the bulging of the fuselage. They
are stuck together from the inside with instant adhesive first to the fuselage and then to the
flap. The gap between fuselage and flap should amount 1 mm. Prepare the two stopping points
“Y” out of a sheet or an epoxy plate and stick them together. The flaps can be shut with the
help of small springs of rubber band.
front b
ulkhead
stopping point
hook
“X”
support of the undercarriage
hinges
direction of flight
flaps
bac
k
b
ulkhead
stopping point
