
21
20
2. Place the Footplate on the hoop and line up with holes of the clips and the
chainstays.
3. Place washers onto each of two bolts and attach them to the frame through
the holes in the Footplate that line up with the rear chainstay hole. Do not
fully tighten.
4. If you will be adding the Skirt Guard accessory, do not attach the front
screw until you are installing the Skirt Guard.
5. Place a washer (not shown) onto each of two bolts and put the bolts
through the holes on the outer edge of the Footplate and through the clips.
6. Place a second washer (not shown) and a nut onto the bottom of the screws
underneath the clip.
7. Tighten all Footplate bolts to 5Nm
8. Repeat the procedure for the other side of the bike.
9. Check weekly to ensure that the Footplate bolts are tight.
10. Have Fun!
ACCESSORY INSTRUCTIONS
ACCESSORY INSTRUCTIONS
Skirt Guard Kit Installation
Included Parts
2 Plastic Skirt Guards
4 M6 Bolts
2 M5 Bolts
2 Skirt Guard Mounting Tabs
Required Tools
Power Drill with ¼” bit and a scrap wood block
Metric bicycle multi-tool or Allen wrench set
Permanent Ink Marker
Micro Torque wrench (optional)
Installation Steps
1. If the Bamboo Footplate Kit (Part # 9000141) has been installed, remove
the inside front mounting bolt (at the chainstay).
2. Place a washer and a Skirt Guard Mounting Tab onto a bolt and screw
the bolt through the front, inboard hole and into the hole in the chainstay.
Make sure the Mounting Tab is oriented so that its vertical surface
faces away from the bike
(1, below).
Summary of Contents for BruHaul
Page 1: ...BrüHaul OWNER S MANUAL ...
Page 14: ......