Once you have access the shredder’s
main menu mode you will see 3 green
lights and one yellow light illuminate on
the Anti Jam Indicator. You will also
see the green power light on.
Upon entering the
shredder’s “Current Limit
Calibration” all of the Anti
Jam indicator lights will
shut off and the Jam
Indicator will illuminate
Current Limit Adjustment
•
Please note if you have a unit with a of serial
number of and after
NA Model JP Model EU/UK Model
130903 130814 130814
•
This process has been eliminated and you will only have to calibrate the anti-
jam
Reference SB 1311-01
The current limit adjustment is preset during manufacturing. After the Control Touch panel
board is replaced, this setting may need to be checked and adjusted. When adjusted
properly, the shredder will not allow more than the maximum recommended sheet capacity
to be shredded.
To check and adjust the current limit setting:
1. Turn on the main power switch at the rear of the shredder.
2. Immediately press and hold the Forward, Reverse, and Power buttons on the control
panel switch and release.
3. Hold the Forward button for 3
seconds. The shredder will start running non-stop.
4. Insert 25 sheets (22 + 3) for models 225i / 225Ci and 17 (14+3) for model 225Mi to
ensure the proper setting
5. The shredder will stop running when the paper is shredded, and both the Jam
Indicator and Power Indicator will shut off. The new Current limit will be set
