Fellowes POWERSHRED P-58Cs, User Manual

Page: 3 / 8

Set to Off (O) and
plug in
3
BASIC PRODUCT MAINTENANCE
Set to Auto-On (l)
Hold card at edge
Set to Off (O) and
plug in Feed into paper entry
and release
Feed into center of
entry and release Set to Off (O)
and unplug
Set to Off (O)
and unplug
Continuous operation:
3-5 minute maximum
NOTE: Shredder runs briefly
after each pass to clear entry.
Continuous operation beyond
3-5 minutes will trigger a
15-minute cool down period.
Set to Auto-On (I)
Check paper
amount
BASIC SHREDDING OPERATION
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
* Apply oil
across entry
Set to Off (O)
PAPER
CARD
Set to Reverse (R)
2-3 seconds
TROUBLESHOOTING
Paper jam:
Set to Off (O), remove shredder head and empty bin. Replace shredder head, and follow any or all of the below procedures.
Alternate slowly back and forth Set to Reverse (R)
for 2-3 seconds Set to Off (O)
and unplug Gently pull uncut
paper from paper
entry. Plug in. Set to Reverse (R)
Indicator lights:
9iœÜʇÊ->vi-i˜Ãi
®
active
9iœÜÊv>à ˆ˜}ʇÊ->vi-i˜Ãi
®
not active
Make sure head is on basket correctly
Wait 15 minutes for motor to cool down
Remove and empty basket
LIMITED PRODUCT WARRANTY
Limited Warranty: Fellowes, Inc. (“Fellowes”) warrants the parts of the machine to be free of defects in
material and workmanship and provides service and support for 2 years from the date of purchase by the
original consumer. Fellowes warrants the cutting blades of the machine to be free from defects in material and
workmanship for 5 years from the date of purchase by the original consumer. If any part is found to be defective
during the warranty period, your sole and exclusive remedy will be repair or replacement, at Fellowes’ option
and expense, of the defective part. This warranty does not apply in cases of abuse, mishandling, failure to comply
with product usage standards, shredder operation using an improper power supply (other than listed on label),
or unauthorized repair. Fellowes reserves the right to charge the consumers for any additional costs incurred by Fellowes to provide parts or services outside of the country where the shredder is initially sold by an authorized
ÀiÃiiÀ°Ê 9Ê *Ê 7,, /9]Ê 1 Ê //Ê "Ê , / /9Ê ",Ê / --Ê ",Ê Ê *,/1,Ê
*1,*"-]Ê-Ê, 9Ê/Ê Ê1,/" Ê/"Ê/Ê**,"*,/Ê7,, /9Ê*,"Ê-/Ê",/Ê "6°Ê˜Ê
no event shall Fellowes be liable for any consequential or incidental damages attributable to this product. This
warranty gives you specific legal rights. The duration, terms, and conditions of this warranty are valid worldwide,
except where different limitations, restrictions, or conditions may be required by local law. For more details or
to obtain service under this warranty, please contact us or your dealer.
ATTENTION: If the SafeSense ® light remains on, you must engage the Override Switch
ʈ˜ÊœÀ`iÀÊ̜ʫiÀvœÀ“ÊÃÌi«ÃÊ>LœÛi°Ê"˜ViÊÌ iʍ>“ʈÃÊVi>Ài`]ÊÀiÃiÌÊÌ iÊ
SafeSense ® feature. (See SafeSense ® instructions below.)
Sensor light illuminated–paper
>““i`
SafeSense ® paper jam: If the SafeSense ® feature activates (SafeSense ® light remains on) to cause
Ì iÊÕÃiÀÊ̜ÊÌ ˆ˜ŽÊÌ iÊà Ài``iÀÊ >Ãʍ>““i`ÊÜ i˜ÊˆÌÊ >ÃʘœÌ]ÊÕÃiÊÌ iÊÊÊÊÊ
Override Switch to deactivate
the SafeSense ® feature and clear the paper. Warning – when switch is in override position, the
SafeSense
®
light will flash and the SafeSense
®
Êvi>ÌÕÀiÊ܈Ê "/Êv՘V̈œ˜°Ê"˜ViÊÌ iÊ«>«iÀʈÃÊVi>Ài`]Ê
reset the SafeSense ® feature.
Disconnect power switch
“ÕÃÌÊLiʈ˜Ê" Ê­®Ê«œÃˆÌˆœ˜Ê̜Ê
operate shredder. Insert waste
bag (Fellowes #36052) for
easy disposal.
SafeSense ® override switch
Active
œÌÊ>V̈Ûi
2 4 3 5 1
3 4
1
2
5
2 1 3
1
4 5 3
6 2
All cross-cut shredders require oil for peak
performance. If not oiled, a machine may
experience diminished sheet capacity, intrusive
noise when shredding and could ultimately
stop running. To avoid these problems, we
recommend you oil your shredder each time
you empty your waste bin.
OILING SHREDDER
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE