User Manual
29 January 2018
16
FELIX Pro 2
www.FELIXprinters.com
Maintenance
Print bed contact points
Make sure to keep the contact points on the bottom of the print bed clean. Use a detergent like alcohol and rub gently
with a paper towel or cloth. Check this regularly, especially, when you remove the bed a lot from the printer.
Dust cleaners
Filament attracts a lot of dust and small particles. Make sure the filament enters the filament holder through the dust
cleaner. After a few months of printing it is recommended to replace the dust cleaners.
Motion system
The linear bearings require almost no maintenance. Recommended is that you put a little some grease on them every
3-4 months.
The belt tension of the x and y axis can also be checked in intervals of 3 months. Check this small movie to see how to
tension the belts.
https://www.youtube.com/watch?v=dpS6nWn5rE8
Make sure the four
contact pads are clean
from grease or debris
