Felix Storch Summit CR430SS, Owner'S Manual

Page: 10 / 16

9
ELECTRICAL CONNECTION

The appliance must be properly installed and grounded by a qualified technician in accordance with
the National Electrical Code ANSI/NFPA No. 70 (Latest Edition) and local electrical code
requirements. Installation should be made by a licensed electrician.

The unit may be connected by means of permanent Hard Wiring or Power Supply Cord Kit. Power
supply cord is not supplied, but is available through your local electric supply house.

Use only 3-conductor or 4-conductor UL listed cord rated at 20 amps with 250V minimum voltage
range. These cords may be provided with strain relief or conduit connector.

The unit must be connected to the proper electrical voltage and frequency as specified on the rating
label.

The unit should be connected directly to the junction box through flexible, armored or nonmetallic
sheathed, copper cable. The flexible, armored cable extending from the fuse box or circuit breaker
box should be connected directly to the junction box. Locate the junction box to allow as much slack
as possible between the junction box and the unit so that the unit can be moved if servicing becomes
necessary in the future.

Do not cut the conduit. Use the length of conduit provided.

For personal safety, the appliance must be properly grounded.

Remove house fuse or open circuit breaker before beginning installation.

Do not attempt to repair or replace any part of the appliance unless it is specifically recommended in
this manual. All other servicing should be referred to a qualified technician.

To minimize the possibility of electric shock, disconnect this appliance from the A/C power supply
before attempting any maintenance.
NOTE: Turning the appliance off does not disconnect the appliance from the power supply. We
recommend having a qualified technician service your appliance.
1. 3-Wire Power Cord Installation
IMPORTANT:
Use the 3-wire cable from power supply where local codes permit connecting the frame-
ground conductor to the neutral (white) junction box wire.
1. Disconnect power
2. Remove junction box cover, if present.
3. Connect the flexible cable conduit (3) from the
cooktop to the junction box (4) using a UL listed or
CSA approved conduit connector (7).
4. Tighten screws on conduit connector if present.
5. Connect the two black wires (1) together using the
UL listed wire nut (5).
6. Connect the two red wires (2) together using the UL
listed wire nut.
7. Connect the green wire (6) to the white (neutral)
wire (6) in the junction box using the UL listed wire
nut.
8. Install junction box cover.
9. Reconnect power.

WARNING

Improper connection of the equipment-grounding can result in the risk of electrical shock. If the
power cord of the unit is damaged, have it replaced by an authorized service center.
1
2
3
4
5
6
7