Felder Hammer, Setup Manual

Page: 51 / 104

All extension tables should be aligned to the cast iron table, using a straight edge
and a feeler guage. Check the alignment across the whole of the table using a
straight edge and a feeler guage to ascertain the difference in height between the
two.
For the rip fence extension table, make checks at the points indicated above with a
straight edge and feeler guage.
Test Point Unit type Tolerance
Parallel to cast iron table Metric 0.0mm to 0.40mm
(Extension table below cast iron) Imperial 0.000” to 0.016”
Alignments
S
R01.1 Rip Capacity Extension Tables
Adjus tm e nt Link