Single LED Fixture Hardwire Installation
4
WWW.FEIT.COM
Please contact 1-866-326-BULB (2852) for further assistance.
1
2
Turn the power OFF from the breaker panel before
starting installation.
Turn Off the Power
5
Carefully remove the knock-out with a flathead screwdriver.
Removing the Knock-out
6
Install the Clamp Connector (HH) to the knock-out hole by inserting
it through the hole and securing it with the nut. The Clamp
Connector (HH) should be on the outer side of the bracket.
Installing the Clamp Connector to the
Knockout Hole
7
Cutting and Stripping Wires
Position the Fixture
Find the desired place for the LED light fixture and mark
clearly using the provided mounting bracket template (DD).
4
Remove the screw on the hardwire bracket, then slide and
lift the bracket off of the fixture.
Removing the Hardwire Bracket
DD
EE
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
HH
3
Screw in the Mounting Screws (CC) on the marked locations,
leaving a gap of 0.08-0.10 inches between the screw head
and the installation surface.
Installing the Mounting Screws
Marked
locations
CC
Take out of the black and white 18AWG wires in the fixture
and the green 18AWG wire (II) in the plastic bag. Cut and
strip the wires to the correct length.
EE
1
2
x
x
3
