4 WWW.FEIT.COM
Retain this manual for future use.
CAUTION:
When installing the panel on a vertical surface, the
mounting plate must be installed in such a way that the mount-
ing tabs are oriented in a vertical position. If the mounting tabs
are not in this position the fixture will not be properly secured
and could fall resulting in serious injury.
BB
AA
AA
Installation
1
Turning Off the Power
2
Identifying the Wires
□
Identify the wiring: (black - line voltage, white -
neutral and green - ground).
3
Attaching the Mounting Plate
□
Attach the mounting plate (AA) to the junction box
using the two #8-32 x 1 in. screws (DD).
□
Align the mounting plate in the direction you want
the fixture to be aligned. Once the toggle bolts are
installed, you cannot change the orientation.
4
Positioning the Toggle Bolts
5
Securing the Toggle Bolts
6
Re-attaching the Mounting Plate
7
Connecting the Fixture
□
Using the mounting plate (AA) as a guide, mark the
position of the holes on the ceiling or wall where the
toggle bolts will be placed.
□
Remove the mounting plate (AA) from the junction box.
□
Hook the support wire from the fixture on the
mounting plate (AA).
□
Drill the marked locations using a 1/2 in. drill bit.
□
Remove the wings from the 3/16 in. toggle bolts (BB).
□
Insert a screw (BB) through the front of the mounting
plate (AA) and reattach the wing to the screw (BB).
Repeat for all toggle bolts.
CAUTION:
Care must be taken not to have excess wires
outside the junction box to avoid pinching wires. This may
cause a short and could lead to a potential hazard.
□
Feed the junction box wires through the center of
the mounting plate (AA) hole.
□
Re-attach the mounting plate (AA) by inserting the
toggle bolts (BB) into the drilled holes.
□
Once the wings (BB) are through and expanded,
pull the toggle bolts (BB) downward to engage and
tighten.
Line voltage
AA
AA
DD
DD
Ground
Neutral
□
Turn the power OFF at the switch and
fusebox or the circuit breaker.
