7
Playback from the analog audio input
Connect an audio source, e.g. MP3 player or TV via the 3.5 mm jack socket
. To playback music or sound, set the MODE
switch to the position
(T/F) and turn on the AVS00200. Now start playback on your device and listen to it via the speakers.
The sound is also output via Bluetooth transmitter and audio outputs. Upon successful coupling with a Bluetooth receiver, e.g.
headphone, the PR and TX LEDs
light up continuously.
Playback from the optical audio input
Connect a sound source, e.g. Blu-ray player or TV via the optical audio input
with a Toslink cable. For music playback, set the
MODE switch to the position
and turn on the AVS00200. Now start playback on your device. Sound output is via Bluetooth
transmitter, speakers and audio outputs.
Bluetooth Transmitter Mode
The AVS00200 can transmit the sound via Bluetooth, the playback can be enjoyed with a Bluetooth headphone or Bluetooth
speakers. To do so, connect the audio source (e.g., TV, MP3 player, or PC) to one of the two audio inputs. Set the switch to
for playback from the analogue audio input
or to
for playback from the digital optical audio input
. Then switch the
amplifier on. The PR LED
starts blinking. The Bluetooth device must be paired with the AVS00200. Upon successful coupling
the PR and TX
LEDs light up continuously.
Bluetooth playback on the optical audio output
You can use the AVS00200 to enable an amplifier with optical audio input for play back via Bluetooth. Play with it e.g. music
from your smartphone via your home cinema system. Connect the audio output
to the optical input of the home cinema
amplifier. Then the AVS00200 must be paired with the audio source. Set the MODE switch to the position
and switch on. The
pairing lamp
PR
starts flashing. Activate the pairing on your Bluetooth device (usually found under „Settings> Bluetooth“).
Then confirm the connection of your smartphone or tablet with the found FeinTech_AVS. The two LEDs RX
and PR
then
light up constantly. Start the music playback on your smartphone or tablet.
Note: All other audio outputs are disabled in this mode.
USB port
A connected device (e.g. smartphone) can be charged via the USB port
.
Important NOTE
The Bluetooth operating mode as transmitter or receiver is determined at power up. If you turn the MODE switch during opera-
tion, this is only adopted when you switch the AVS00200 on the next time.
Technical data
Power output
2 x 20 W RMS 4
Ω
or
2 x 10 W RMS 8
Ω
Input sensivity
680 mV
Frequency response
20–20.000 Hz
Channel separation
95 dB
Total harmonic distortion THD
< 0,1 % @ 1W per channel
Efficieny
> 90 %
Minimum impedance
4
Ω
Supported data formats
MP3, WMA, WAV
Signal to Noise Ratio (SNR)
105 dB, A-weighted
Bluetooth-Version
3.0+EDR
Dynamic range
> 100 dB
Bluetooth Codecs
SBC, FastStream, aptX
Chipset
TDA7491HV
Dimensions
12 x 4 x 16 cm
