26
en
Instructions for core drilling.
Do not stop the drill motor during the drilling
procedure.
Only remove the cutting tool from the hole
while the motor is running.
If the carbide tipped cutter should remain
stuck in the material, stop the drill motor and
carefully turn the carbide tipped cutter out
counterclockwise.
After each drilling operation, remove the
chips and the slug.
Do not touch the chips with your bare
hands. Always use a chip hook (6 42 01
001 00 0).
Danger of burning!
When changing a cutting tool, pay attention
not to damage the cutting edges.
For core drilling in layered material, use a suit-
able Slugger ID cutter.
When core drilling layered material, remove
the core and the chips after having drilled
through each layer.
Error message/
Response of magnet
button
Meaning
Corrective action
Indicator lights up
green
Magnetic holding power possi-
bly sufficient.
Indicator flashes
green
Magnetic holding power insuf-
ficient.
Even when working on steel materi-
als where the material thickness is
below 9 mm, the workpiece must be
made thicker with an additional steel
plate in order to ensure the magnetic
holding power.
Indicator flashes red
once or several times
–
Motion sensor has actuated
–
Overload shut-off has actu-
ated
–
Hand lever not set to 100 %
position
–
Buttons for left rotation/right
rotation blocked
–
Check battery indication
After malfunction correction, the
power tool can be switched on again.
Indicator lights up red
continuously
Power tool is defective.
Send the machine to your Slugger
customer service agent.
Indicator does not
light up
–
The machine is in sleep func-
tion
–
Battery dead or defective
–
Power tool is defective
–
Actuate magnet button (sleep func-
tion is deactivated).
–
Check battery indication
–
Send the machine to your Slugger
customer service agent.
OBJ_BUCH-0000000282-002.book Page 26 Tuesday, December 5, 2017 10:35 AM
