21
en
Feed without the capstan handle (Fig. 16).
➤
Depending on the application, the feed
can also be actuated without the capstan
handle. For this, apply the socket span-
ner.
➤
With the motor running, manually
turn the socket spanner.
Instructions for core drilling.
Only remove the core bit from of the drilling
hole while the motor is running.
If the core bit should remain stuck in the
material, stop the drill motor and carefully
turn the core bit out anti-clockwise.
Remove the chippings and the bored core
after each drilling process.
Do not touch the chippings with your
bare hand. Always use a chip hook.
When changing a drill bit, pay attention not to
damage the cutting edges.
When core drilling layered material, remove
the core and the chippings after drilling each
layer.
30 mm
Fig. 16
3 41 01 126 21 0.book Seite 21 Donnerstag, 21. Januar 2010 1:48 13
