![background image](http://html1.mh-extra.com/html/fein/asse-636-2b-kinetik/asse-636-2b-kinetik_manual_4047464010.webp)
10
ASse 636 - 2b Kinetik
EN
Operating the power tool.
Switching ON/OFF (3).
■
First check that the cable and plug are
not damaged.
Switching the power tool ON:
■
Press switch (a). Speed according to
how far the switch is pressed in.
Switching the power tool OFF:
■
To turn off, release switch.
Locking for continuous mode:
■
When the switch (a) is fully pressed in
(= maximum speed) press the locking
button (b).
■
To release, press switch (a) again and
then let go.
Select direction of rotation (4).
■
Set the direction of rotation using
selector switch for clockwise and anti-
clockwise rotation.
Only operate when power tool is at a
standstill.
Changing the insert.
Risk of injury
by switching the tool ON unintentionally.
Before changing the tool, pull out the mains
plug.
■
Pull of the bit stop (1) with a turning
movement.
■
Remove the insert.
■
Notch in a new insert.
■
Mount the bit stop (1) using a turning
movement.
Adjusting the torque.
The power tool is fitted with a single jaw
clutch coupling. The torque can be
changed by adjusting the depth engage-
ment of the clutch.
A greater depth of engagement produces
a greater torque and a lesser depth a
smaller/lower torque.
The adjustment is carried out by turning
the torque adjusting key (2).
■
Unscrew the bearing sleeve and
remove the screwed pin.
■
Turn the torque adjusting key (2) in the
desired direction.
Turning the screw/key clockwise to the
next notch will increase the depth engage-
ment by 0.16 mm. The depth engagement
is pre-set at the factory to approx.
0.75 mm.
■
Unscrew the bearing sleeve
(10 – 12 Nm).
The torque is dependent upon the force at
which the power tool is pressed against
the screw.
Setting the bit stop (6-9).
Risk of injury
by switching the tool ON unintentionally.
Before adjusting, pull out the mains plug.
The bit stop consists of a connecting col-
lar (g) and a stop collar (h). One full turn
of the stop collar (four notching intervals)
changes the screwing depth by 1 mm.
■
Mount the bit stop (1) using a turning
movement.
■
As a preliminary setting, set the stop
collar such that it is flush with the sur-
face of the screw.
■
Screw in one sample screw as far as the
stop.
!
!
ASse 636 -2b .book Seite 10 Donnerstag, 28. Juni 2001 8:55 08