TST
Assembly instructions
FUZ2 -A/-B/-C/-CX/-G/-L
FEIG ELECTRONIC GmbH
Page 89 of 96
TST_FUZ2-A-B-C-CX-G-L_Montageanleitung_EN_22.docx
13.2 Information messages
No.
Description
I.021
Emergency open test is running
I.080
Service counter will run off
I.100
Speed in open position to high
I.150
Speed in close position to high
I.160
Permanent open comand still active
I.161
Priority still active
I.170
Forced opening active
I.180
Wait for foil key command
I.185
Wait for reset by stop foil key
I.199
Door counter wrong
I.200
New reference position taken over
I.201
Reference position new initialized
I.205
Synchronisation done
I.210
Limit switch not plausible (pre limit open)
I.211
Limit switch not plausible (pre limit close)
I.310
Open command to door 2
I.320
Obstacle during opening
I.325
Obstacle during closing
I.360
Disturbed N.C. safety edge
I.363
Disturbed N.O. safety edge
I.380
Faulty 2nd internal N.C. safety bar
I.383
Faulty 2nd internal N.O. safety bar
I.510
Correction drive finished
I.515
Active correction drive
I.520
Target speed for opening or closing move not reached
• Pre-limit switch reached before full speed was reached --> adjust ramps
• Current limiter prevents movement at full speed --> Inverter or motor working at performance limit
--> adjust ramps or limiter
I.555
Measuring rotation factor not ready
I.610
Light line alignment completed successfully.
I.615
Light line alignment requested.
I.620
Door in PU when syncing but some rays of light are still masked.
Adjust P.446 door masking in PU!
I.621
The resolution of the installed position encoder is too low to maintain robust light curtain operation.
More increments are required per door move. (Message only occurs when DIP-Switch is ON.)
