OBID
i
-
scan
®
Installation
ID ISC.SPAD102
FEIG ELECTRONIC GmbH
Page 22 of 32
M10414-1de-ID-B.doc
E
N
G
L
I
S
H
10 Assembly and Wiring
The antenna is intended for the indoor use on a plane surface (desktop) or for mounting behind or
under a mounting plate (non-conductive).
For the operation on a plane surface, rubber bumpers are mounted on the backside of the anten-
na.
The mounting behind or under a mounting plate can take place via domes, which are suggested
with bore holes on the backside of the antenna housing.
The surface of the acrylic glass plate is protected by a foil to avoid scratches from
transport and installation work. After the installation, the protection foil can be re-
moved carefully, starting at a corner.
10.1 Dimensions
The dimensions and the mounting holes of the shielded pad antenna are shown in the following
picture.
All dimensions are shown in mm (inch):
37
6,
2
(1
4,
81
)
275,7 (10,85)
28
0
(1
1,
02
)
21
5
(8
,4
6)
14
0
(
5,
51
)
42
,8
(
1,
68
)
240 (9,44)
6
x Ø
1
,5
(0
,0
6)
Figure 1: Dimensions of the antenna and positions of mounting holes (backside)
