OBID i-
scan
®
MONTAGE / INSTALLATION
ID ISC.PRH102-B
FEIG ELECTRONIC GmbH
M91100-2de-ID-B
Technische Daten
Technical Data
Gehäuse / housing
Kunststoff ABS / Plastic ABS
Gewicht / weight
320 g (ohne Batterien / without batteries)
Schutzart / protection class
IP 30
Spannungsversorgung / Supply voltage
4 aufladbare Batterien / 4 rechargeable AA batteries
Leistungsaufnahme / power consumption
max. 2,5 W / VA
Betriebsfrequenz / Operating frequency
13,56 MHz
RF-Sendeleistung / RF- transmitting power
200 mW
2 dB
Antenne / Antenna
1 x integrated HF antenna
Unterstützte Transponder / Supported Transponder
ISO 15693
Schnittstellen / Interfaces
Serial Port Profile
Temperaturbereich / Temperature range
Betrieb / Operation
Lagerung / Storage
0 °C to +50 °C
-20 °C to +70 °C
relative Luftfeuchte / Relative air humidity
95 % (nicht betauend / non-condensing)
Die Funkanlage entspricht, bei bestimmungsgemäßer Ver-
wendung den grundlegenden Anforderungen des Artikels 3
und den übrigen einschlägigen Bestimmungen der R&TTE
Richtlinie 1999/5/EG vom März 99.
Equipment Classification gemäß
ETSI EN 301 489: Class 2
When properly used this radio equipment conforms to the
essential requirements of Article 3 and the other relevant
provisions of the R&TTE Directive 1999/5/EC of March 99.
Equipment Classification according to
ETSI EN 301 489: Class 2
FCC ID: PJMPRH102
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
NOTICE:
Changes or modifications made to this equipment not expressly approved by FEIG ELECTRONIC GmbH may void the
FCC authorization to operate this equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in ac-
cordance with the instructions, may cause harmful interference to radio communications. However, there is no guaran-
tee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
