Feig Electronic OBID i-scan ID ISC.MR200-E Application Note Download Page 6

Page: 6 / 7

OBID i-

scan

Application-Note

ID ISC.MR200-E

FEIG ELECTRONIC GmbH

Page 6 of 7

N40901-0e-ID-B.doc

3. Installation of Digi Device Discovery

Please unzip the file dgdiscvr.zip and copy the file “dgdiscvr.exe” onto the hard disc of your PC.

4. Change the TCP-IP address

1. Connect the ID ISC.MR200-E reader via the TCP/IP interface to the PC and switch the power

supply on.

2. Start the program “Digi Device Discovery” by double click onto “dgdiscvr.exe”

3. The following window appears and the program shows the current default TCP/IP address

(192.168.10.10) of the reader.

4. If the reader has been detected press the button “

Configure network settings

”.

Summary of Contents for OBID i-scan ID ISC.MR200-E

Page 1: ...APPLICATION NOTE preliminary public B 2004 09 20 N40901 0e ID B doc OBID i scan ID ISC MR200 E How to change the TCP IP address ...

Page 3: ...n Note ID ISC MR200 E FEIG ELECTRONIC GmbH Page 3 of 7 N40901 0e ID B doc Content 1 Safety Instructions Warning Read before start up 4 2 Introduction 5 3 Installation of Digi Device Discovery 6 4 Change the TCP IP address 6 ...

Page 5: ... ID B doc 2 Introduction This description describes how the TCP IP address can be configured on the ID ISC MR200 E reader using the tool Digi Device Discovery dgdiscvr exe Later reader versions will be able to change the TCP IP address by using the demo program ID ISOStart ID ISC MR200 E ...

Page 7: ... settings IP Address and Subnet Mask Then press the button Save 6 The updating process will take a few seconds 7 After the process has been finished the new TCP IP address should be displayed 8 Close the program Digi Device Discovery and check the function using the ID ISOStart program or any other program which support the TCP IP interface ...