Feig Electronic ID ISC.MRMU102-A, Installation Manual

Page: 27 / 36

OBID i-scan
®
Montage / Installation ID ISC.MRMU102-A
FEIG ELECTRONIC GmbH Seite 27 von 36 M10410-2de-ID-B.doc
12.3.1 Power Supply
Power supply recommendations:
To take full advantage of the Reader performance, you must use a sufficiently regulated and low-
noise power supply. When using a switching power supply, be sure that its internal switching fre-
quency is less than 300 kHz. See also:
Accessories
Feig Article No Part No. Description.
1688.002.00 ID NET.12V-B-EU Power Supply 95 - 265V AC Input Voltage,
with angular DC Plug 2,5mm*5,5mm
Output: 12 V DC/ ; 700mA
Ambient Operating Temperature: 0°C to +40°C
3886.000.00 ID NET.12V-B-GB
3887.000.00 ID NET.12V-B-US
Table 6: Recommended power supply
Note:
•
The power supply is supplied with a DC plug 2.5mm x 5.5mm. This is compatible with
the plug of the Serial data cable ID CAB.RS-A .
•
The reader always needs to be supplied with an external power supply.
12.3.2 RS232 Interface
Interface parameter can be configured via software protocol (e.g. ISOStart). Further information
can be found in the System Manual H10410-Xe-ID-B.pdf of the reader.