IDENTIFICATION Installation
ID
ISC.M02.M8
FEIG ELECTRONIC GmbH
Page 16 of 16
M02M8-IM-e_02.doc
The manufacturer is obliged to test the terminal device together with the reader module according
to the national FCC requirements according to 47 CFR Part15 §209 and §225
For this purpose the reader module must be set to normal operation, ScanMode. The Scan mode
is switched with on by SW command: Transparent Command - ISO 14443A [ReqA] HEX: 02 00 0A
FF 00 30 02 01
The manufacturer is obliged to test the terminal device together
with
the reader module according
to the national FCC requirements according to 47 CFR Part15 §209 and §225 For this purpose the
reader module must be set to normal operation, ScanMode. The Scan mode is switched with on by
SW command: Transparent Command - ISO 14443A [ReqA] HEX: 02 00 0A FF 00 30 02 01
The manufacturer is obliged to test the terminal equipment
without
RF transmitter, according to
the national FCC requirements according to 47 CFR Part 15 Subpart B. For this purpose, the HF
transmitter of the reader module must be switched off. The HF transmitter is switched off by the
SW command: Transparent Command - HF Off HEX: 02 00 0A FF 00 04 01 00
FCC-/IC-NOTICE: To comply with FCC Part 15 Rules in the United States / with IC Radio Stand-
ards in Canada, the system must be professionally installed to ensure compliance with the Part 15
certification / IC certification. It is the responsibility of the operator and professional installer to en-
sure that only certified systems are deployed in the United States / Canada.
