Identification
Integration Manual
ID ISC.LRM1002-E
FEIG ELECTRONIC GmbH
Page 9 from 23
M21110-3e-ID-B.docx
3.2.1.1 Connection of a ID ISC.DAT (Dynamic Antenna Tuning Board)
For tuning a ID ISC.DAT tuning board a DC voltage is required. This DC voltage must be provided
via a power splitter (ID ISC.ANT.PS-B) or a antenna multiplexer (ID ISC.ANT.MUX)
Figure 4 shows the DC supply of the ID ISC.DAT with a power splitter.
Figure 4: DC supply of a ID ISC.DAT using a power splitter ID ISC.ANT-PS-B
Figure 5 shows the DC supply of the ID ISC.DAT with a Antenna Multiplexer.
Figure 5: DC supply of a ID ISC.DAT using a ID ISC.ANT.MUX.
