OBID
®
classic-pro
INSTALLATION
ID CPR40.30-A
FEIG ELECTRONIC GmbH
Page 6
M80803-0de-ID-B.doc
Radio Approval
Europe
USA
EN 300 330
FCC 47 CFR Part 15
Elektromagnetische Verträglichkeit / EMC
EN 301 489
Sicherheit / Safety
Niederspannung / Low Voltage
Human Exposure
EN 60950
EN 50364
Umwelt und Stoffverbote / Waste and Hazardous
Substances
WEEE - 2002/96/EC
RoHS - 2002/95/EC
Die Funkanlage entspricht, bei bestimmungs-
gemäßer Verwendung den grundlegenden Anfor-
derungen des Artikels 3 und den übrigen einschlägi-
gen Bestimmungen der R&TTE Richtlinie 1999/5/EG
vom März 99.
Equipment Classification gemäß
ETSI EN 300 330 und ETSI EN 301 489: Class 2
When properly used this radio equipment conforms
to the essential requirements of Article 3 and the
other relevant provisions of the R&TTE Directive
1999/5/EC of March 99.
Equipment Classification according to
ETSI EN 300 330 and ETSI EN 301 489: Class 2
FCC ID PJMCPR4030
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired op-
eration.
Any changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio fre-
quency energy and, if not installed and used in accordance with the instructions, may cause harmful inter-
ference to radio communications. However, there is no guarantee that interference will not occur in a par-
ticular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the interfer-
ence by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
