ORIGINAL INSTRUCTIONS
13
2. Stopping the engine
Allow the chainsaw to run for a few minutes. Then turn the switch to the OFF position.
3. Main settings
a. Adjusting the carburetor
The carburetor is preset at the factory. To avoid malfunction, it is recommended not to adjust the adjustment
screws. If these screws require readjustment, have the machine serviced by your service center.
Stop the tool and tighten the needle L until it stops. Do not force it. Then set it to its initial number of turns as
shown below. The number of turns for the needle is also shown below:
b. Chain brake
The chain brake is a device that automatically stops the chain in case a backward movement occurs, causing
the saw to jump. Normally, the brake is automatically activated by the inertia force.
It is also manually tightened by pushing the brake lever down and forward.
When the brake is running, a yellow sign comes out from the base of the brake lever.
To release the brake, pull the brake lever up until it clicks into place.
When the brake is working, release the throttle lever to slow down the engine speed. Continuous use when
the brake is running causes the clutch to heat up and can cause problems.
When checking the machine before using it, check the operating condition of the brake by performing the
following operations:
Start the engine and grasp the handle firmly with both hands.
While pulling the throttle control lever to keep the chain in operation, push the brake lever down with the back
of the left hand.
When the brake is running and the chain is stopped, remove the hand from the throttle.
Loosen the brake.
