Feider Machines FSOR254S2L, Instruction Manual

Page: 21 / 26

ORIGINAL INSTRUCTIONS
5. MAINTENANCE
Warning! Prior to any adjustment, maintenance or service work disconnects the mains power plug!
General maintenance measures
Wipe chips and dust of the machine from time to time using a cloth. In order to extend the service life of
the tool, oil the rotary parts once monthly. Do not oil the motor. When cleaning the plastic do not use
corrosive products.
Cleaning the moving saw blade guard safety device (9)
Always check the saw blade guard for debris before using the machine.
Remove old sawdust and splinters using a brush or similar tool.
Replacing the table insert
Danger!
• With a damaged table insert (19) there is a risk of small parts getting stuck between table insert and
saw blade, blocking the saw blade.
Immediately replace damaged table inserts!
1. Remove screws at table insert. If required, turn rotary table and incline saw head to be able to reach
the screws.
2. Remove table insert.
3. Install new table insert.
4. Tighten the screws at table insert.
Brush inspection
Check the carbon brushes after the first 50 operating hours with a new machine, or when new brushes
have been fitted. After carrying out the first check, repeat the check every 10 operating hours. If the
carbon is worn to a length of 6 mm, or if the spring or contact wire are burned or damaged, it is
necessary to replace both brushes. If the brushes are found to be usable following removal, it is
possible to reinstall them. When servicing the carbon brushes, open the two latches counterclockwise .
Then remove the carbon brushes. Replace the carbon brushes in the reverse order.
If the supply cord of this power tool is damaged, it must be replaced by a specially prepared
supply cord available through the service organization.
Storage
Store the device and its accessories in a dark, dry and frost proof place that is inaccessible to children.
The optimum storage temperature is between 5 and 30˚C.
Store the electrical tool in its original packaging.
Cover the electrical tool in order to protect it from dust and moisture.
Store the operating manual with the electrical tool.
21