ORIGINAL INSTRUCTIONS >EN
8
4. OPERATION
WARNING !
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION: Make sure that the Trigger is in
the off-position and unplug the tool from its electrical outlet before performing any procedure in this
section.
4.1 Changing Bit Holders
1) Twist and pull forward on the Depth Collar to remove it from the Head Cover, see Figure A.
2) Pull the Bit Holder straight out with pliers if it is difficult to remove.
3) Push the new Bit Holder into the Spindle until the shank of the Bit Holder snaps in place.
4) Replace the Depth Collar onto the Head Cover. Align the ribs on the inside of the Depth Collar with the
grooves on the outside of the Head Cover before snapping the Depth Collar in place.
Figure A: Remove Depth collar
4.2 Changing the Bit
1) Twist and pull forward on the Depth Collar to remove it from the Head Cover, see Figure A.
2) Pull the Bit straight out with pliers if it is difficult to remove.
3) Push the new Bit into the Bit Holder until the shank of the Bit snaps in place.
4)
Replace the Depth Collar onto the Head Cover. Align the ribs on the inside of the Depth Collar with the
grooves on the outside of the Head Cover before snapping the Depth Collar in place.
4.3 Work piece and Work Area Set Up
1) Designate a work area that is clean and well-lit. The work area must not allow access by children or pets
to prevent distraction and injury.