TO SET VARIABLE SPEED SWITCH
Select right speed for each material like plastic, wood and metal by turning the Variable speed
switch to set from 1 to 6 Grades (Please see above picture).
Following are the recommended cutting speed for different materials and Maximum thickness for
cutting:
Material to be Cut
Speed Grade
Maximum Material Thickness (mm)
PLASTIC
CUTTING:
CUTTING:
Grade
mm
ALUMINUM
CUTTING:
Grade
5-6 5
14
1-4
4
5
Grade
mm
STEEL CUTTING:
Grade 4-6
5 mm (and 3mm wall thick steel tube)
WOOD
5-6
45
mm
STONE & TILE CUTTING: Grade 6
2
5
mm
Note: If the user feels the machine is not powerful enough to use the recommended cutting speed,
because the material properties are different, some harder, some softer and the material
thickness are different; the user can slightly increase the cutting speed around the recommended
speed range.
OPERATING INSTRUCTIONS
Protect saw blades against impact and shock.
Guide the machine evenly and with light feed in the cutting direction. Excessive feed
significantly reduces the service life of the saw blade and can cause damage to the power tool.
Sawing performance and cutting quality depend essentially on the condition and the tooth form
of the saw blade. Therefore, use only sharp saw blades that are suited for the material to be
worked.
SAWING MATERIAL
The correct selection of the saw blade depends on the type and quality of the wood and
whether length way or crossway cuts are required. When cutting spruce length ways, long spiral
chips are formed. Beech and oak dusts are especially detrimental to health. Therefore, work
only with dust extraction.
