4. OPERATION
Warning.
Do not connect the saw to power source until assembly is complete. Failure to comply could result
in accidental starting and possible serious injury.
Warning.
4.1 CUT-OFF WHEEL REMOVAL
1)
Be sure the tool is disconnected from the power source.
2)
Raise the tool to its fully open position, remove nut on the blade cover and rotate the lower wheel guard
downward, exposing the hex head bolt which secures the abrasive wheel to the wheel arbor.
3)
Push in the shaft lock lever and rotate the wheel until the safety lock level engages, locking the wheel in
place.
4)
While holding the shaft lock lever in place, use a wrench and loosen the hex head bolt by rotating it
counterclockwise. Remove the hex bolt, washing, outside flange and abrasive wheel.
4.2 CUT-OFF WHEEL INSTALLATION
1)
Be sure the tool is disconnected from the power source.
2)
Inspect the replacement wheel for defects such as cracks, chipping, and correct speed rating. If defects
are found or the speed rating is not greater than 4400RPM discard the wheel and select another.
3)
Remove any debris from the inside flange and inner washer. Position the new abrasive wheel over the
inner washer and against the inside flange.
4)
Clean and align the outside flange to the wheel arbor, then slide it onto the arbor until it rests flush
against the abrasive wheel.
5)
Insert the hex head bolt onto the threaded end of the wheel arbor and rotate it in a clockwise direction
until snug. Then depress the shaft lock lever to prevent the shaft from rotating, use the supplied wrench
to securely tighten the hex head bolt to hold the abrasive wheel firmly in place.
Warning. Do not over tighten the hex bolt. Over tightening can cause the new wheel to crack,
resulting in premature failure and possible serious injury.
6) Return the wheel guard to its lowest position and replace nut to secure wheel guard.
4.3 DOUBLE ACTION SAFETY SWITCH
To prevent unauthorized use of the cut off saw, only when pressing both the trigger and the padlock, the
machine can be operated.
4.4 ADJUSTABLE STATIONARY VICE
The adjustable stationary vise is located on the base of your cut-off saw. This vice can be rotated to attain
cutting angles from 0 to 45 degrees and moved rearward to allow greater cutting widths.
9
1.Don't use the cut-off machine without protective cover on suitable position.
2.The recommended thick of grinding wheel is 2.8mm, and diameter of wheel's hole is 25.4mm.
3. The maximum cutting capacity of cut-off machine is
1
3
0
mm.
