1. Fill the tank with fresh filtered fuel.
2. Insure that your receiver and ignition batteries are charged, your receiver
and transmitter are on. , and that your throttle is set to low.
3. Close the choke and turn on the ignition switch.
4. Rubber stick is recommend to start the engine.
5. Begin flipping the prop through its compression stroke until the engine fires.
6. Wait for the propeller to stop spinning, turn off the ignition, and open the
choke(s)
7. Switch the ignition back on and flip the propeller again until the engine starts
8. Warm up the engine for 15 or 20 seconds before advancing the throttle.
Carburetor Tuning and Care
The use of a tachometer is highly recommended. And, again, never adjust the
needles while the engine is running!
Tuning
1. Using the tachometer tune the engine for maximum power with the high
needle (H).
2. Using the tachometer again: richen the high needle (H) until the motor runs
100-200 RPM
less than the maximum RPM. Now you should richen slightly on the high
needle (H).
Keep the engine run at idle for 60 seconds. Insure that the idle RPM to be
constant. If the low needle (L) is too rich, it may happen that idle RPM drops
until the engine stops;. Lean the low needle (L) until a constant idle RPM is
achieved.
Check the transition with a quick throttle advance. It should sound like it is
making quick steady power.
Care:
Your carburetor screen will need to be cleaned with clean gasoline and blow off
with compressed air after every flight. Check the choke and throttle plates for
tightness.
Trouble Shooting
Problem1.
The engine is flooded.
Solution:
Remove the spark plug; turn the engine to a position where the fuel runs out
and clean it.
Check the connections of spark plug, screws, restart the engine, if it failed to
start again, please send it back to After-sale service center for repair.
Problem 2.
The engine starts after being choked but then stops soon after.
Solution:
