Lock tubes together by rotating the center tube in the opposite direction to end tube. HOLD TUBES LOCKED WHILE YOU
INSTALL FIRST SELF-DRILLING SCREW ON A DRILL LINE, 1“ (2.5 cm) back from end of center tube at Location ”C1”
(see Fig. 3 & 4).
Place 2 more self-drilling screws at Location “C2” & “C3” - 1 screw at every second drill line
around tubes (see Fig. 3).
At “D” locations install 3 screws around the center tube at every second drill line, 1“ (2.5 cm)
back from where you marked the end of the inner tube from Fig. 2A (see also Fig. 3).
Repeat for other end tube.
STEP 3: ASSEMBLE ENDS
Fig. 7
Strap end
3. FG-502
Wheel
FG-002
Wheel Stop
FG-1B END
1. FG-PLGL
(3“ diam. Tube)
IMPORTANT:
FG-CK1
FG-CK1
FG-BH END
1. FG-PLGL
(3“ diam. Tube)
FG-BH
PLACE LONG SIDE OF
TRIANGLE TOWARD LONGEST
SECTION OF COVER.
Assemble in numerical order (see Fig. 5 or 6):
Fig. 6
5 . W h e n e n d s a r e
assembled insert screw
through tube in line with
bump on plug rim, 1“ (2.5
cm) from tube end - at
BOTH ends.
Bearing
2. FG-BEA005
3. End
Bracket
4. FG-HANC
Handle
Fig. 4
B.
C.
D.
E.
C3
C2
End tube
End tube
Center tube
C
D
C1
C1
Fig. 3
Drill lines DO NOT
line up when tubes
are locked
Drill lines DO NOT
line up when tubes
are locked
Tubes Must be in Locked Position
Drill Lines DO NOT line up when tubes are locked
D3
D2
D1
D1
THIS STEP REQUIRES A TOTAL OF 12 SELF-DRILLING SCREWS
DO NOT pre-drill holes or over-tighten screws.
STEP 2: TUBE ASSEMBLY - CONTINUED
Fig. 5
Plugs:
1. FG-PLG
(31/2“ diam. Tube)
OR
Insert Plug (#1) into End Tube.
(Use the 2 plugs with appropriate
diameter for your tube. You can discard the other set)
Place Bearing (#2) inside End Bracket
or
Wheel (#3).
Push Handle (#4) through Bearing and into Plug.
Insert 1 self-drilling screw (#5) through tube in line with bump on
plug rim and 1“ (2.5 cm) from tube end. (see Fig. 7).
Repeat for other end.
Insert
Screw
5. Insert Screw 1“ (2.5 cm) from
tube end (See Fig. 7)
5. Insert Screw 1“ (2.5 cm) from
tube end (See Fig. 7)
2. FG-BEA005
Bearing
4. FG-B-HAN
Plugs:
1. FG-PLG
(31/2“ diam. Tube)
OR
Tube End
Strap Plate
Strap end
Fig. 8
STEP 4: STRAP ATTACHMENT
Attach a Strap Plate to EACH end
of all Straps provided (see Fig. 8).
Cover End
Strap Plate
Strap
To Insert Casters, please see attached
CASTER INSERTION instructions.
