Feel Good RK7911, User Manual

Page: 8 / 15

11 12
Step 4. How to assemble the left and right armrest.
①
Unscrew the M6 on the seat frame with cross screwdriver.
②
Press the button on the fixed hole which
inside the back of armrest,insert fixed hole into the fixed bolt of side backrest.
③
Insert the square tube
into the inside piece of the seat frame.
④
Slightly move the armrest to make the front and back panel
match bolt hole on the seat metal frame,screw M6 on the hole.
⑤
Connect the air hose from seat frame
with the hose joint on the armrest firmly.
⑥
Joint LED wire on the armrest with the LED wire on the seat.
During installation,please make sure don't squeeze the air hose and LED wire.
Disassemble armrest:
Disassemble the shoulder device and seat side airbags at first,
disconnect the LED wire and air hose between the seat frame and armrest,Then unscrew the
four bolts on the seat frame.Lift up the front of the armrest,make the square tube of armrest
move out from the plate of seat frame,then press the button on the fixed hole which at inside
of the rear of armrest,pull the rear of armrest at the same time,move the fixed bolts on the side
of backrest away from the fixed hole,then it finished to disassemble the armrest.
▲
Side pieces of seat
meal frame
Fixed hole
Button
Fixed panel
Square tube Air hose LED wire
①
②
③
Bolts
Fixed bolt
⑤
Purple air hose
⑥
Four bolts in the four corners
④
Step 5. Install left and right shoulder massage device
▲
When assemble the left and right shoulder massage device,please note,left shoulder massage device
assemble on the left side of backrest, right shoulder massage device assemble on the side of backrest.
①
Two hands to grab the shoulder massage device to make the inside parts close to the side of backrest,
connect the wire of loud speaker and air tube from shoulder massage device with the connector from
the side of backrest.
②
Make the four axle holes on the armrest align to the four axles on the backrest,
put strength to insert the axle to the axle hole,make close to the shoulder and back.
③
Turn the shoulder
massage device downward,until it can't be moved,then it was fixed well.
④
Pull the shoulder bag leather
zipper, open shoulder bag holster, gasbag fixed plate mounting holes on the bottom board and enchase
nut at the top of the armrest after alignment;
⑤
Using M6X30 screw insertion on the screw hole, screw
tightly by a cross screwdriver, then pull the shoulder holster zipper;
⑥
Repeat the above steps to install
another shoulder massage device.
Disassemble shoulder massage device: Unzip the shoulder airbags,screwing out the screws inside
the air bag;Turn the shoulder parts upwards,move the axle away from the axle hole,then disconnect the
wire of loudspeaker and airtube.
Right shoulder
massage device
Left shoulder
massage device
Right side
of backrest
Left side
of backrest
Connector for wire
of loudspeaker and
air tube
①②
Four axles
Four axle holes
①②
Zipper for
shoulder
airbags
Cross screwdriver
screwing in bolt
⑤
Bolt
③
LED wire