Vision
®
SLR with Standalone SignalMaster
®
Supplement
4
Vision SLR with Standalone SignalMaster
Federal Signal
www.fedsig.com
Figure 3 Wires inserted into connector
290A6428
TIP OF SMALL
SCREWDRIVER
STRIPPED
WIRES
1. INSERT SCREWDRIVER
TIP INTO RECTANGULAR
HOLE.
2. INSERT STRIPPED WIRE
END IN ROUND HOLE.
3. REMOVE SCREWDRIVER.
1/4"
WIRE STRIPPING
TYPICAL
3.
Ensure that each SignalMaster control wire is in the proper position. Connect the eight-position
connectors together, and apply pressure until they lock.
4.
After installation, test the light system to ensure that it is operating properly.
5.
Test all vehicle functions, including horn operation, vehicle safety functions, and vehicle light systems,
to ensure proper operation. Ensure that the installation has not affected the vehicle operation or
changed any vehicle safety function or circuit.
