SmartSiren Platinum Convergence Network
Federal Signal www.fedsig.com
Connecting the Convergence Network
16
Connecting the Convergence Network
Before permanently installing the SmartSiren
®
Platinum system, plan all wire
routings and select the mounting locations for the siren amplifier/relay module and
control head. Read and understand all instructions included with related equipment
before installing it.
Selecting Mounting Locations
When fastened to the back of the control head, the mounting bracket covers the wiring
connectors and a supplemental control for the gain or volume of the radio rebroadcast
feature. To facilitate the installation of the SmartSiren Platinum system, select mounting
locations for the control head and the siren amplifier/relay module before permanently
mounting them in the vehicle. After completing the wiring described in this chapter,
refer to the instructions for mounting the control head and the siren amplifier/relay
module in “Mounting the Siren and Control Head” on page 39.
AIRBAG DEPLOYMENT: Do not install equipment or route wiring in the
deployment path of an airbag. Failure to observe this warning will reduce
the effectiveness of the airbag or potentially dislodge the equipment,
causing serious injury or death.
SEAT REMOVAL PRECAUTION: If a vehicle seat is temporarily removed,
verify with the vehicle manufacturer if the seat needs to be recalibrated for
proper airbag deployment.
UNRESTRICTED AIR FLOW REQUIRED (SSP3000B ONLY): The siren
amplifier is cooled by an internal fan. Do not install it in areas where air flow
is restricted. Do not mount the unit near a heater duct or under the hood.
MODULE IS NOT WATERPROOF: The housing of the siren amplifier/relay
module is NOT waterproof. The module must be mounted in a location that
is sheltered from falling rain, snow, standing water, etc.
For the control head, select a mounting location that allows the vehicle, controls,
and microphone to be operated safely under all driving conditions. To identify
safe mounting areas for equipment inside the vehicle, consult the vehicle
manufacturer’s guidelines. To avoid driver distraction and unreliable switch
activation, the mounting location must not allow any movement of the control head.
Do not select a heated surface for the mounting location of the control head. For
the siren amplifier/relay module, suggested mounting locations are under the
dash, under the front seat, or in the trunk under the rear deck near the rear seat
speakers. Wiring connectors are located on the back of the siren amplifier/relay
