Chapter 6: Setting Control Pad Options
39
PA300-CN Siren Amplifier
Entering Program Mode
See Figure 6.1. To set the keypad options, first enter Program Mode:
1. Press and hold Button 6 while powering up the control pad.
2.
During the long beep, release
Button 6
. The control pad beeps continuously.
3.
Verify that the first amber LED is on.
Turning Off or On the 10-Second Notification Beep
To turn the beep off or on:
1.
While in Program Mode, press
Button 12
.
2.
To continue, select another setting to change or press
Button 13
to exit Program Mode. Verify that the
last amber LED turns on when you exit.
Dimming or Turning Off the Button LEDs
To dim or turn off the button LEDs:
1.
While in Program Mode, press
Button 8
up to four times to step though decreasing levels of brightness.
To turn off the LEDs, press
Button 8
a fifth time.
2.
To continue, select another setting or press
Button 13
to exit Program Mode. Verify that the last amber
LED turns on when you exit.
Resetting to the Factory Default Configuration
To reset the operation and control of network devices to the factory default:
1.
While in Program Mode, press
Button 7
.
2.
To continue, select another setting to change or press
Button 13
to exit Program Mode. Verify that the
last amber LED turns on when you exit.
Exiting Program Mode
To exit Program Mode
1.
Press
Button 13
.
2.
Verify that the last amber LED turns on when you exit.
Summary of Contents for Smart Siren
Page 2: ...blank page...
Page 51: ...blank page...
