290A3620
LENS
LIGHT
ASSEMBLY
REMOVE 2
TORX SCREWS
PULL LENS STRAIGHT AWAY
FROM LIGHT ASSEMBLY
CAUTION
THE USE OF LONGER SCREWS MAY DAMAGE
THE CIRCUIT BOARD ASSEMBLY. USE THE
PREVIOUSLY REMOVED SCREWS WHEN
REPLACING THE LENS.
Figure 3.
CAUTION
Service life of lamp will be shortened if glass is touched.
If glass has been handled, clean with a grease solvent.
WARNING
A serious injury may result if lamp is touched when hot.
Always allow lamp to cool before removing. Halogen
lamps are pressurized and if broken can result in flying
glass. Always wear gloves and eye protection when
handling the lamps.
2.
Remove the defective lamp by carefully pulling it
out of the socket. Install a new lamp by aligning the pins on the
lamp base with the holes in the socket, and carefully pushing the
lamp into the socket.
CAUTION
Use of longer screws may damage the circuit board
assembly. Use the previously removed screws when
replacing the lens.
3.
Replace the lens using the previously removed
screws.
VI.
REPLACEMENT PARTS.
Description
Part No.
Lens, Clear
8573001
Lens, Red
8573001-01
Lens, Amber
8573001-02
Lens, Blue
8573001-03
Lens, Green
8573001-04
Lamp, 27-watt halogen,
8573007
G.E. GH-22
Cable Assembly, 15-ft.
175846
Cable Assembly, 35-ft.
175846-01
Reflector and Terminal Assy.
8573180
Screw, Torx, #10-32
7011163-04
PCB Assembly
2001228
Switch Kit Assembly
8573157
VII. SERVICE.
Communication and shipments should be addressed to:
Service Department
Federal Signal Corporation
2645 Federal Signal Drive
University Park, IL 60466
1-800-433-9132
-4-
