44
I/O and Terminal Block Cards
PAGASYS GEN II (P-SYS-G)
Federal Signal www.fedsig.com
Table 25 Environmental and Physical for the Access Panel Aggregator Card
(P-APIC-G)
Operating Temperature
-25 to +55°C
Humidity
0-98% non-condensing
P-APIC-G Dimensions (H x W x L)
30 mm x 200 mm x 122 mm
Weight
0.18 kg/0.40 lb
3.2 Digital Input I/O Card (P-16DIN-G)
The Digital Input card (P-16DIN-G) is one of several I/O boards designed specifically for
integration into the PAGASYS GEN II system. (See Figure 22.) These I/O boards use a
standard control interface that greatly simplifies the internal wiring of the cabinets.
The Digital Input card provides 16 individual digital inputs that you can individually
configure to support dry contact mode or 24 V PLC mode. Also, the card provides status
LEDs for each input that, when illuminated, indicates when the input is activated. The
inputs are monitored by the Controller.
Figure 22 Digital Input I/O Card (P-16DIN-G)
In dry contact mode, the input senses a short between the plus and minus pins to activate
the input; an open circuit between the plus and minus pins deactivates the input.
In 24 V PLC input mode, the input senses 24 V applied across the plus and minus pins to
activate the input. Removal of the applied 24 V deactivates the input.
NOTE
: The service model for the Digital Input I/O card is K-P-16DIN-G.
