17
Operation
Installation and Maintenance Instructions
Federal Signal www.fedsig.com
Operation
LIGHT HAZARD: This product contains a high intensity LED
device. To prevent permanent eye damage, DO NOT stare into
the light beam at close range.
When the search light is powered on, it will perform a calibration
procedure. It will rotate to zero and return to the last position it
was at when powered off.
Select a unit to be controlled from one of the three presets by
pressing its button. If it is paired and connected, it is made the
active connection, and the button turns solid green. If it is only
paired, the controller scans for up to 30 seconds (the button
flashes blue while scanning) or until it connects. (The button
turns solid green.) If no search light has been paired for the
selected button, the button flashes red briefly, and if the last
active search light is still connected, it will be selected.
Power the unit on and off using the power button.
Aim the light to the work area by using the Up-Down and Left-
Right buttons.
Adjust the spot size by using the spot in and spot out buttons.
Once a desired position is reached, this may be programmed as
a preset by pressing the M1 or M2 buttons for five seconds until
the Power button blinks. If the light is moved from this position,
it may be returned to by pressing the selected memory button.