3
IPX-SW1 Side-Window Mounting Brackets
DRILLING PRECAUTIONS
Before drilling holes, check the area you are drilling into to be
sure you do not damage vehicle components while drilling. All
drilled holes should be de-burred and all sharp edges should be
smoothed. All wire routings going through drilled holes should be
protected by a grommet or convolute/split loom tubing.
5. Center-punch the marks and use a #21 drill bit to drill three 0.159"
holes.
6. Connect the
I
mpaxx
or
V
Iper
exT
lightheads as described in the in
-
structions provided with the lightheads.
7. Replace the door panel assembly according to the manufactures in
-
structions.
8. Repeat steps 1 through 7 with the other side.
9. Test the lightheads for proper operation.
290A6034
BRACKET
6-32 SCREWS (4)
6-32 NUTS (4)
IMPAXX
#10 TYPE B
SCREWS (6)
NOTE: USE INNER 3.125"
HOLES IN END BRACKETS
FOR IMPAXX; OUTER 3.625"
HOLES FOR VIPER EXT
Figure 1: Lighthead attached to side window bracket
