Safety Message to Installers of Warning Light Equipment
People’s lives depend on your safe installation of our products. It is
important to read, understand and follow all instructions shipped
with the products. In addition, listed below are some other important
safety instructions and precautions you should follow:
•
To properly install a light assembly, you must have a good under
-
standing of automotive electrical procedures and systems, along with
proficiency in the installation and use of safety warning equipment.
•
Before drilling into a vehicle structure, be sure that both sides of the
surface are clear of anything that could be damaged.
•
You should frequently inspect the light system to ensure that it is op
-
erating properly and that it is securely attached to the vehicle.
•
Refer to the instructions packed with related products for additional
precautions and information.
•
File these instructions in a safe place and refer to them when main
-
taining and/or reinstalling the product.
Failure to follow all safety precautions and instructions may result in
property damage, serious injury, or death to you or others.
Mounting Brackets for
I
mpaxx
™ and
V
Iper
™ EXT
This booklet has instructions for using the IPX-SW1 Side Window Mount
-
ing Brackets to mount the
I
mpaxx
and
V
Iper
EXT lightheads to the rear
side-window of the Ford Crown Victoria.
Unpacking the Kit
After unpacking the kit, carefully check all envelopes, shipping labels, and
tags before removing or destroying them. Ensure that the parts listed in
Table 1
on page 2 are contained in the packing carton.
2562403A
REV. A 508
Printed in U.S.A.
Installation Instructions for IPX-SW1
Side-Window Mounting Brackets
