290A3372
STRIP
CRIMP
INSERT
CONNECT
DIRECTLY TO
POWER SOURCE
CONNECT
DIRECTLY TO
SCENE
LIGHT ASSEMBLY
CONNECTOR
FROM SCENE
LIGHT ASSEMBLY
FROM
USER
SUPPLIED
CABLE
1 2
Figure 2.
d.
Install the new halogen lamp in the rear housing
using the previously removed screws and clips.
e.
Replace the trim ring and lens and secure with
the previously removed screws.
f.
Reconnect all power connections to the power
source and test for proper operation.
E.
REPLACEMENT PARTS.
Description
Part No.
Lamp, Halogen
8575107
Lens, Blue, Fluted
8575095-01
Lens, Red, Fluted
8575095-03
Lens, Amber, Fluted
8575095-05
Lens, Clear, Fluted
8575095-07
Gasket, Lens
8575096
Gasket, Flange
8575097
Hardware Packet
8575115
SAFETY MESSAGE TO OPERATORS
Peoples’ lives depend on your safe use of our products.
Listed below are some important safety instructions and
precautions you should follow:
•
Although your warning system is operating
properly, it may not be completely effective.
People may not see or heed your warning signal.
You must recognize this fact and continue driving
cautiously.
•
Also, situations may occur which obstruct your
warning signal when natural or man-made
objects are between your vehicle and others, such
as: raising your hood or trunk lid. If these
situations occur, be especially careful.
•
At the start of your shift, you should ensure that
the light is securely attached and operating
properly.
•
Failure to follow these safety precautions may
result in property damage, serious injury, or
death to you, to passengers, or to others.
RETAIN AND REFER TO THIS MESSAGE
290A3373
GHSCENE LIGHT ASSEMBLY
LENS
TRIM RING
LAMP
TRIM RING
SCREWS(4)
LAMP
MOUNTING
SCREWS(2)
LAMP
MOUNTING
CLIPS(2)
Figure 3.
-2-
D.
MAINTENANCE.
1.
General.
WARNING
Crazing (cracking) of lenses will cause reduced
effectiveness of the light. Do not use cleaning agents
(which will cause crazing) such as strong detergents,
solvents, or petroleum products. If crazing of lenses
does occur, reliability of light for emergency signaling
purposes may be reduced until lenses are replaced.
Ordinary cleaning of the plastic lenses can be
accomplished by using mild soap and a soft rag. Should fine
scratches or a haze appear on a lens, they can ordinarily be
removed with a non-abrasive, high quality, one-step, automo-
tive paste cleaner/wax and a soft cloth.
2.
Halogen Lamp Replacement.
WARNING
A serious injury may result if lamp is touched when
hot. Always allow lamp to cool before removing.
Halogen lamps are pressurized and if broken can
result in flying glass. Always wear gloves and eye
protection when handling the lamps.
a.
Disconnect all power to the light before perform-
ing any maintenance.
b.
See figure 3. Remove and retain the four screws
which secure the trim ring and lens. Carefully pull the trim
ring and lens straight away from the flush mount light
assembly.
c.
Remove and retain the two screws and clips
which secure the lamp. Remove the lamp by pulling it straight
away.
WARNING
This device is designed to use a 20 watt (maximum)
halogen lamp. Use of higher wattage lamps can result
in damage to the lens, property damage, or serious
injury to you or others. Always use a 20 watt halogen
lamp.